Ничего не загорится и не взорвется :
Брюс Винке - (цитирую High Pressure Combustive Oxygen Flow Simulations, B.R. Wienke, Los Alamos National Laboratory, Los Alamos, N.M. 87545, они там исследовали зависимость вероятности возгорания от процентного содержания кислорода, давления и размеров частиц примеси):
Five drive pressures, 1000 psi up to 5000 psi, were considered for ignition and burn. Particulate densities ranged 50 mg/ft^2 up to 300 mg/ft^2 for the tabulation. Only hydrocarbons (plastic, silicone, nylon) ignited in the study. Glass, titanium, aluminum, and fiber did not ignite. For drive pressures above 3000 psi, only 70% oxygen and above ignited the hydrocarbon assemblies, provided the assembly densities were greater than 200 mg/ft^2. Below 3000 psi, high oxygen fractions (90%) were necessary for ignition and burn, with the same particulate distributions. Two component mixtures, with hydrocarbon particulate density above 200 mg/ft^2, ignited but the quenching component of the distribution (metal, glass) reduced the burn wave intensity. Below 5 mg/ft^2 dirt density, ignition and burn were not observed.
Для тех, ктo, в английском не силен, краткий смысл: при давлении меньше 200 бар загорается только при содержании кислорода 90% и более и плотности примеси 2 грамма на квадратный метр, при этом углеводородные примеси сгорают, а материал баллона не горит.
При содержании кислорода менее 70% для возгорания требуется давление более 400 бар.
Best regards, Deep Star.